EXCP Explosion Proof Combination & Non-Combo Starters

Non-Combination Catalog

Combination Catalog

EXCP hinged cover motor control enclosures are used:

For general motor control & circuit protection – indoors & outdoors – in damp, wet, dirty, dusty hazardous locations without the need for a protective shelter
In areas where frequent washdowns are necessary or where heavy rain or water spray is prevalent
For across-the-line starting, stopping, speed changing & reversing of polyphase AC induction motors
To provide line disconnect means & short circuit protection
To provide motor overload & undervoltage protection
For service entrance, feeder or branch circuit protection for lighting, heating, appliance & motor circuits
On switchracks or other assemblies where it’s desired that motor control be centrally located

Rugged, corrosion resistant, cast copper-free aluminum construction
Circuit breaker handle with lock out tag out (for combo starters only)
Total compliance to the wiring bend room requirements of the National Electrical Code*/Canadian Electrical Code
Circuit breaker motor circuit protector external operating handle can be padlocked in either “ON” or “OFF” positions
NEMA 4 watertight cover gasket permanently attached to the cover seals out moisture
Bodies have top & bottom drilled & tapped entrances for power conduits plus one at the bottom for control conduit.
Tap-on mounting feet – Retro fit mounting hardware kits are made for the EXCP line enclosures to mount directly in the same footprint as the listed manufacturer.
Optional EXCP control devices may be added to enclosure cover

Body & cover – Copper free aluminum
Gasket – Neoprene
Cover bolts
Hinges – Aluminum
Motor starters – NEMA/EEMAC sizes 0-6
Circuit breakers – 100, 150, 225, 250, 400, 600, 800, 1200 ampere frame sizes
Motor circuit protectors – 150, 250, 400 ampere frame sizes 1000 Ampere Frame (max. 800 ampere trip)